PLC

PoLabs and Lego Maters 2017

By |March 27th, 2017|CNC, CNC controller, CNC Machine, Logic analyzer, Other, PC oscilloscope, PLC, PoKeys, PoScope, Signal generator, Stepper driver, Stepper motor, USB oscilloscope|

PoLabs was sponsoring the Lego Master 2017 competition on Faculty of Electrical Engineering, University of Ljubljana Quoted from source: http://lego-masters.si/ The fifth contest Lego Masters is behind us. The organizers would like to thank all the participants that they devoted the last few months to preparations for the competition, which they also attended. Special thanks also [...]

New communication options in PoBlocks

By |January 21st, 2017|CNC, CNC Machine, Home automation, PLC, PoKeys|

PoBlocks just got a set of new communication features in PoKeys57 series ethernet devices. UDP sender enables PoKeys device to send simple messages using UDP protocol on request from the PoBlocks project. PoKeys InterCom protocol on the other hand enables sending data between PoKeys devices. PoKeys (Simple) UDP sender As the name applies, UDP sender [...]

PoBlocks tutorial – Pulse engine, custom PoIL code

By |May 27th, 2016|Home automation, Other, PLC, PoKeys, Stepper driver, Stepper motor|

In this PoBlocks tutorial, we will describe how PoBlocks can be used to solve a stepper motor positioning task. PoBlocks is a graphical programming tool for PoKeys device and is free of charge for PoKeys users. Background We have been approached by one of our users on how a positioning system can be implemented using [...]

RC simulator interface – PPM signal decoding

By |February 7th, 2016|PLC, PoKeys|

Some users asked us to implement the support RC simulator interface, that would decode the data from a general purpose R/C (remote control) receiver in order to control outputs of the PoKeys device and/or allow the PoKeys device to be used as RC simulator interface. Allow us to present how easy is to use PPM [...]

Load More Posts